Amada RG35S-100, Operator'S Manual, Page: 43 / 110

IV-5
[3] Multiple opening limit setting lever
Used to set the multiple opening limit (stop position) of the ram. Open
the ram to the position where you want to stop the ram, and turn down
the lever to set the stop position. Turn up the lever to clear the stop
position and open the ram to the maximum opening limit.
[4] Pressure gauge
Indicates the pressure applied between the punches and dies when the
cut-off valve knob is turned fully counterclockwise.
[5] Cut-off valve knob
Used to stop the flow of hydraulic oil to the pressure gauge so that the
pressure gauge does not indicate the pressure. Turned fully clockwise
when there is no need to check the pressure.
[6] Multiple closing limit setting handwheel
Used to set the multiple closing limit of the ram. Turned clockwise to
raise the multiple closing limit and counterclockwise to lower the multiple
closing limit when the handwheel lock knob is turned fully
counterclockwise.
NOTICE
O
Do not turn the multiple closing limit setting handwheel counterclockwise with
the bar pedal pressed and held. Doing so may break the multiple closing
limit setting mechanism and render the machine unusable.
[7] Handwheel lock knob
Used to lock the multiple closing limit setting handwheel after setting the
multiple closing limit of the ram with the handwheel. Turned fully
clockwise to lock the handwheel.
NOTICE
O
When the handwheel lock knob is overloosened to unlock the multiple closing
limit setting handwheel, the handwheel may not be locked again. To loosen
the knob, turn it once to twice.
[8] Rising speed change position setting lever
Used to change the rising speed of the ram from the approach speed to
the bending speed (low speed).
[9] Digital multiple closing limit display (Digicollar)
Located behind the multiple closing limit setting handwheel and
indicates the current position of the ram set with the handwheel. Press
the reset button alongside the display to reset the display to “0”.