Amada RG35S-100, Operator'S Manual, Page: 36 / 110

III-8
2-6. Supplying hydraulic oil
The hydraulic unit is located at the rear of the machine. Remove the
top cover or covers of the hydraulic oil tank, and pour the recommended
hydraulic oil into the hydraulic oil tank to the specified level of the oil
gauge. The specified level is near the middle mark of the oil gauge
when the ram is at the maximum opening limit. (Refer to “2.
Maintaining hydraulic system” in Part VI.)
Model Tank capacity
RG35S 26 L {6.9 US gal}
RG50, RG80 51 L {13.5 US gal}
RG100 65 L {17.2 US gal}
Recommended hydraulic oil: Amada Oil A-110
Esso Nuto H46
Mobil DTE 25
Shell Tellus Oil 46
(ISO VG46 equivalent)
The hydraulic oil Super Hyrando 56 of Nippon Oil Co., Ltd. is delivered
with the machine.
2-7. Supplying electric power
WARNING
O
Have a qualified electrician perform all
electric work to prevent accidents and
damage.
O
Before making the electrical connections,
be sure to turn off the shop circuit breaker.
O
Be sure to connect the grounding
conductor for safety.
Connecting power source
Connect the power source to the machine as described below.
1 Turn off the machine circuit breaker and the shop circuit breaker.
2 Pull the three-phase power cable through the power inlet at the
bottom of the electrical enclosure, and connect it to the L1, L2 and
L3 primary terminals of the terminal block.
3 Securely connect the grounding conductor to the ground terminal.
After wiring the power cable, check the voltage with a tester.
Primary power cable Four-conductor cable
Input power source
200/230/380/400/460 VAC±10%, 3 phases,
50/60 Hz±1 Hz