Amada RG35S-100, Operator'S Manual, Page: 79 / 110

V-35
5 With the bar pedal fully pressed, slowly turn the multiple closing
limit setting handwheel clockwise.
The ram slowly closes. (Its multiple closing limit rises.)
6 When the clearance between
the punches and punch holders
is about to disappear, turn the
multiple closing limit setting
handwheel further clockwise,
while checking the pressure
gauge, in order to apply the
pressure until the pointer of the
pressure gauge indicates the
NC9 value.
PRESSURE
GAUGE
WARNING
O
If the allowable tonnage of the installed
tools is smaller than the NC9 value, set
their origin with a pressure smaller than
the allowable tonnage.
7 Tighten the handwheel lock knob to lock the multiple closing limit
setting handwheel.
8 Press the bar pedal two to three times until the dies completely
engage with the punches.
9 Pull forward the bar pedal lock
lever, and release the bar
pedal.
The bar pedal is locked, and the
ram is fixed in that position.
BAR PEDAL LOCK LEVER
PULL
FORWARD
10 Retighten the fixing bolts of the
punch clamping plates. (If the
optional one-touch punch
holders are used, retightening
their levers is not necessary.)
11 When the dies are 2V-dies or
sash forming 1V-dies, tighten
their fixing bolts.