Amada RG35S-100, Operator'S Manual, Page: 51 / 110

V-7
5 With the bar pedal
fully pressed, turn the
multiple closing limit
setting handwheel
clockwise to set the
height between the
punch holders and die
holders to the
dimension H plus 2 to
3 mm {0.08 to 0.12
in.}.
H + 2 to 3 mm
{0.08 to 0.12 in.}
2 to 3mm
(0.08 to 0.12 in.)
2 to 3 mm
{0.08 to 0.12 in.} 2 to 3 mm
{0.08 to 0.12 in.}
NOTICE
O
Do not turn the multiple closing limit setting handwheel
counterclockwise with the bar pedal pressed and held. Doing so may
break the multiple closing limit setting mechanism. Even when the
handwheel is turned counterclockwise, the ram does not open.
O
To adjust the multiple closing limit of the ram to a lower position, release
the bar pedal to open the ram, turn the multiple closing limit setting
handwheel counterclockwise, and press the bar pedal again.
6 Release the bar
pedal, and turn up the
multiple closing limit
setting lever to clear
the multiple opening
limit of the ram.
The ram opens to the
maximum opening
limit.
7 Clear the pedal stopper, press the bar pedal again to close the ram
to the position you want to set as the multiple opening limit, and
hold the bar pedal in that state.
The ram stops in that position.
8 Turn down the
multiple opening limit
setting lever to set the
multiple opening limit
of the ram.
NOTE
O
Positively turn down the multiple opening limit setting lever so that the
ram does not open.
9 Release the bar pedal.
The ram remains at the multiple opening limit.