Amada RG35S-100, Operator'S Manual, Page: 56 / 110

V-12
5-2. Installing dies
Install the dies on the ram as described below.
Installing 2V-dies
NOTICE
O
Install 2V-dies so that the
V-groove to be used faces
the rear of the machine by
considering safety in the
event of die breakage.
When the die holders are
installed with the step facing
the rear as shown right, the
V-groove to be used comes
to the rear.
O
When using two or more die
holders, install them with a
clearance of about 5 mm
{0.2 in.} between them.
REAR
REAR
STEP
FRONT
(OPERATOR SIDE)
FRONT
(OPERATOR SIDE)
ABOUT 5 mm {0.2 in.}
ABOUT 5 mm
{0.2 in.}
NOTE
O
When using two or more dies, install them so as to create no gap between
them.
1 Place the die holder for the 2V-
die on the top of the ram.
DIE HOLDER
2 Set the die fixing bolts
as shown right.
SPRING
WASHER
BOLT
a + 2 mm {0.08 in.}
3 Slide the 2V-die from
the front of the
machine onto the die
holder with the V-
groove to be used
facing the rear.
4 Fasten the die holder
with the die holder
fixing bolts.
DIE FIXING BOLT
DIE HOLDER FIXING BOLT
2V-DIE
DIE HOLDER