Amada ML-3015AS, Operation Manual, Page: 94 / 204

94
ML-3030AS/3015AS
4 . Setting the Laser Light Output Schedule
<Notes>
- If the output count set in "SHOT" is smaller than that set in "SHOT [count]", any
larger output count set in "SHOT [count]" is invalidated .
When the output count set in "SHOT" is larger than that set in "SHOT [count]",
the POWER of the final set value in "SHOT [count]" is repeated until the output
count reaches the output count set in "SHOT ."
For example, supposing that "SHOT" is set to 40, up to 40 shots are also vali-
dated for "SHOT [count] ." (Up to 40 of POINT 03 on the above screen) When
"SHOT" is set to 300, the POWER of the final set value is repeated up to 201 to
300 shots for "SHOT [count] ." (In this case, the 20% energy of POINT 06 is re-
peated up to 201 to 300 shots .)
- To protect the laser oscillator, the minimum power (ML-3030AS: 0 .5 kW, ML-
3015AS: 0 .25 kW) of laser is output for the set laser output time regardless of the
laser output value (%) .
3
Enabling the Fade Function
(1) Press the "SEAM" setting button to set it to ON.
The fade-in/out function for seam welding is enabled.
⇒
When the fade-in/out function is not used, keep the "SEAM" setting button OFF.
⇒
When the laser light output count is set to 9999 by using the "SHOT" setting but-
ton, a laser light is continuously output until the laser stop signal is input and the
fade-in/out function becomes disabled.