Amada ML-3015AS, Operation Manual, Page: 185 / 204

Timing Chart
185
ML-3030AS/3015AS
Single . . . Operation by control panel (PANEL CONTROL)
The following diagram shows the lapse of time in the case where the "BEAM" setting
button is pressed and "BEAM 1" is set to ON on the control panel, and then laser light
is output from input unit 1 after the safety shutter is opened.
*1 5s (1h) max.
LD on time. When the temperature of fiber laser module is 10°C or
more, the time is 5 seconds max.
The signal is not output until the temperature of fiber laser module
becomes 10°C. (1 hour max.)
*2 1s max.
LD output preparation time. In the REPEAT mode, the signal is kept
turned off for certain time after laser output to keep the average
power below the maximum rated output. The signal is not output un-
til a valid schedule is selected.
*3 150ms or more
Shutter operation time. After BEAM selection, a laser start input
signal is input after the lapse of certain time for shutter operation.
*4 Time required for the end signal to be output after a laser output
*5
Time required for outputting a signal to indicate whether the laser
energy is within the set upper limit value (HIGH) and lower limit
value (LOW) of monitor output
In *4 and *5, the output time is 20 ms but can be changed to 30 or 40 ms on the CONFIG screen.
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
150ms or more
Laser beam is projected from
Laser Beam Input Unit 1
*5
The time set on the CONFIG screen *4
Laser beam is projected from
Laser Beam Input Unit 1
LD-ON/OFF Input *
LD ON Output
Ready Output
Beam Select 1 Input *
(except ML-30□□AS-110)
Laser Start Input *
(Laser light)
End Output
Monitor Normal/
Trouble Output
(*: Operation on the user side)
5s (1h) max . *1
1s max . *2
*3