Amada ML-3015AS, Operation Manual, Page: 116 / 204

116
ML-3030AS/3015AS
3 . Operating Procedure
⇒
For setting the number of continuous laser light outputs, set the number of out-
puts per second in "REPEAT" in the range of 1 to 1000 pps (pulse per second).
⇒ For setting the number of laser light outputs, set it in "SHOT" in the range of 1 to
9999. When 1 is set, a single output is performed.
3
Outputting Laser Light
WARNING
Be sure to put on specified protective glasses during laser light output operation.
Even if you wear them, you may lose your sight if the laser beam enters your eyes
directly through protective glasses .
<Note>
For ML-30□□AS-110, it has no safety shutter and no beamsplitter. Since no window
is displayed even if the “BEAM” setting button is pressed, bypass Steps (4) to (6) .
When the CONTROL keyswitch is turned ON after starting the Laser, the button is
displayed in blinking light blue .
(1) Press the "STATUS" button to display the STATUS screen.
When Pin No.25 (control switching) of the EXT. I/O (1) connector remains in an
open state, external input signals are disabled and "PANEL CONTROL" is dis-
played in "CONTROL DEVICE."
(2) Adjust the workpiece and output unit positions to set an appropriate work dis-
tance (distance between the workpiece and the output position).
(3) Press the "LD" setting button.
The LD lights up.