Amada ML-3015AS, Operation Manual, Page: 171 / 204

1 . Error Display and How to Take a Measure
171
ML-3030AS/3015AS
Chapter 2 Inspection and Measure T
o Be T
aken at Occurrence of an Error
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
No . Contents of error LD
Alarm
output
Measures
027 AC POWER DOWN(PDI) OFF ON
A temporary blackout of AC power supply was de-
tected.
Check the power supply environment.
028 INTERLOCK SIGNAL ERROR OFF ON
An error of unknown cause has occurred with the
interlock.
Consult us.
029 SHUTTER BOARD 5V ERROR OFF ON
A 5V DC power error has occurred with the shutter
drive board.
Consult us.
035 LASER POWER OUT OF RANGE - -
The monitor value of laser energy is out of the
range of "HIGH" and "LOW" set on the MONITOR
screen. → P.70, P.103, P.105, and P.123
Check "HIGH" and "LOW" settings. If monitored
value is abnormal, consult us.
036
LASER CONTROL PARAMETER
ERROR
OFF ON
A set value of laser energy (PEAK POWER, output
time, REPEAT) exceeds the capacity.
The error message is displayed when inputting the
set value. The set value is reset to the value before
the change.
037 VIBRATION DETECTED OFF ON
Shock and vibration has been detected.
Check around any other trouble. After checking that
nothing is damaged, press the RESET button.
050
to
054
POWER FEEDBACK OVERFLOW
to
POWER FEEDBACK4 OVERFLOW
OFF ON
The power set by the power feedback cannot be
output.
When interlock is operated during laser output,
this error may occur. If E050 to E054 occurs alone,
consult us.
060 POWER FPGA ERROR1 OFF ON
An error has occurred with the controller unit.
Consult us.
061 POWER FPGA CALC. ERROR OFF ON
An error has occurred with the controller unit.
Consult us.
062 DIV BY 0 ERROR OFF ON
An error has occurred with the controller unit.
Consult us.
067 INTERNAL RS-232C ERROR OFF ON
The communication line in the main unit is abnor-
mal.
If there is any noise generation source nearby,
separate it as far as possible or take a preventive
measure for occurrence of noise.
068 INTERNAL RS-232C TIMEOUT OFF ON
The communication line in the main unit is abnor-
mal.
If there is any noise generation source nearby,
separate it as far as possible or take a preventive
measure for occurrence of noise.
069 PANEL 485COMM TIMEOUT OFF ON
The communication line in the main unit is abnor-
mal.
If there is any noise generation source nearby,
separate it as far as possible or take a preventive
measure for occurrence of noise.