Amada ML-3015AS, Operation Manual, Page: 46 / 204

46
ML-3030AS/3015AS
2 . Connecting the Optical Fiber
(6) If the dirt cannot be removed by the air blow, apply HYPERCLEAN (EE-3310) on
the cleaning paper. Place it on the optical fiber and wipe the optical fiber by pull -
ing the cleaning paper across it.
(7) Check the end face with the end face checker again. If there is stain, dust and
streak, repeat above steps.
(8) Check that there is no stain, dust and streak and mount it on the output unit (Step
2 ).
2
Connecting the Optical Fiber
(1) Insert the key provided on the optical fiber plug along the groove on the output
unit side.
⇒
At this time, take care that the end face of the
optical fiber does not contact with the output
unit. The end face of the optical fiber and the
ferrule are the same height.
GOOD BAD
Key
Groove
Cap nut
Fiber
Ferrule
Same
height
Cap nut