Amada ML-3015AS, Operation Manual, Page: 169 / 204

1 . Error Display and How to Take a Measure
169
ML-3030AS/3015AS
Chapter 2 Inspection and Measure T
o Be T
aken at Occurrence of an Error
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
Chapter 2
●
Inspection and Measure To Be
Taken at Occurrence of an Error
1 . Error Display and How to Take a Measure
When an error occurs in the laser, the contents of the error are displayed
on the control panel screen as shown below . In the following, how to take a
measure is explained in the order of Error No . At occurrence of an error, read
this chapter carefully and perform inspection of the laser and take a proper
measure .
* If you have any unclear point, contact the distributor or us for information.
⇒ When there is any related page in this Operation Manual, the reference page is
shown.
<Note>
If the safety interlock is activated, a safety circuit will work to stop the safety
shutter and timesharing unit (depending on specifications) forcibly . For this
reason, “SAFETY SHUTTER OPEN/CLOSE TROUBLE” or “BRANCH MIRROR
OPEN/CLOSE TROUBLE” may be displayed other than the relevant error/fault
message .
LD "-": State of LD doesn’t change even if an error/fault occurs.
LD "OFF": LD is turned off automatically if an error/fault occurs.
Alarm output "-": Error/Fault signal is not output if an error/fault occurs.
Alarm output "ON": Error/Fault signal is output if an error/fault occurs.
Maintenance Part
Error No .
Contents of the error
(Troubles are displayed up to
ten occurrences .)