Altigen Altiware OE 4.5, System Administration & Installation Manual, Page: 180 / 455

Board Configuration
AltiWare OE System Installation & Administration Manual 151
Boar
d
Conf
igur
ation
Setting Up an AltiServ-to-AltiServ IP Network
Two or more AltiServ systems can be networked together to provide
extension-to-extension connections via IP trunk calls. Users may dial a
remote AltiServ’s auto attendant or direct dial to an extension, without
having to dial out through the PSTN. A diagram illustrating a multiple
AltiServ-to-AltiServ connection is provided below and is referred to as an
example throughout the configuration instructions below.
Figure 6. AltiServ-to-AltiServ Connection
Follow the steps below to configure IP trunks for an AltiServ-to-AltiServ
tie-trunk line connection:
1. Confirm that the correct number of Triton VoIP boards are installed
and connected by checking the Boards window on the Main Window
of AltiWare Administrator. Refer to “Boards View Window” on page
93 for more details about this window.
2. Assign the IP trunk access code on the Number Plan tab window of
System Configuration. See “IP Trunk Access” on page 107.
3. Configure general trunk parameters on the General tab window of
Trunk Configuration. See “Setting General Trunk Attributes” on
page 173.
4. Configure the dialing plan for connection to remote AltiServ systems
on the IP Dialing Table tab window of System Configuration. Set