On some of the wireless transmitters the PowerCode ID code is printed on a sticker, which is placed on t
of the IC in the transmitter. This is an 8 digit code. If
op
the code is on the sticker, you can use this code to
rogram the transmitter into the wireless interface.
ake sure all 8 digits are entered. The PowerCode transmitter is now recognized by the wireless interface.
ic
put transmits, when activated, its own ID code. This ID code is the code
sed by the magnetic c 1.
n the ID code of the magnetic contact is
98410229
, the ID code of the
xtra input will be
98410230
.
its.
this case also the tamper report of the magnetic contact is send with the ID code of the extra input.
s
ct. To program the ID code of the wireless lapstreak detector, the ID code + 1 must be
rogrammed.
d yet,
ese fields will be empty. The zone names are only displayed here for extra information and ease.
eld
s interface receives
e transmission sent with the correct ID code, the status and field strength are shown.
he status information is displayed as follows:
SABTRs
restore reports, e.g. magnetic contact
.”
When of these options is not active
ultiple options can be visible at the same time, for example:
S...Rs
ervision report, transmitter capable of sending restore reports, supervision reports
enabled.
p
Enter the number of the zone (1-8) you wish to program. When the ID code is known, you can enter it here.
M
Wireless magnetic contact MCT-302
The ID code of a wireless magnetic contact can also be entered in the programming screen. The magnet
contact also has an extra input, which can be used to connect a wired detector on. (PIR detector, wired
magnetic contact, etc.) This extra in
u
Example: when the ID code of the magnetic contact is
08111981
, the ID code of the extra input must be
programmed as
08111982
. Whe
e
Hint: this extra input can very easily be used to connect a wired detector on. Using a dipswitch in the
magnetic contact, the magnetic contact itself can even be deactivated, so that only the extra input transm
In
Wireless glass break detector MCT-501
The MCT-501 is a wireless glass break detector, which uses the transmitter circuit board of the wireles
magnetic conta
p
Next to the input numbers, the zone names are displayed. The zone names can
only
be programmed and
edited in the AlphaVision NG control panel programming, so if there are no zone names programme
th
When the ID code has been entered, the status and field strength are shown instantly. The status and fi
strength information are shown separately for each input and is only visible when the cursor is on the
specific input number, and when the correct code has been entered, or when the transmitter is learned into
the memory of the wireless interface. When the transmitter is activated, and the wireles
th
T
S Tamper
transmission
A Alarm
transmission
B
Low battery report
T Supervision
transmission
R
Transmitter is capable of sending
s
Transmitter supervision enabled
“
M
AlphaVision NG installation manual Rev. 2.0 27-08-2003 Blz. 67/101
means that the tamper switch has been opened, there is no alarm, the battery works fine, this
was no sup
