If you wish to change another setting of this zone, press <#> to continue to the next setting. If this setting
must be changed, use the <
↑
> and <
↓
> keys to change the setting. If the desired setting is visible, press the
<#> key to confirm. The display will then change to:
Special safe-
zone: NO
If you wish to change another setting of this zone, press <#> to continue to the next setting. If this setting
must be changed, use the <
↑
> and <
↓
> keys to change the setting from YES to NO. If the desired setting is
visible, press the <#> key to confirm. The display will then change to:
Zone activates
doorbell NO
If you wish to change another setting of this zone, press <#> to continue to the next setting. If this setting
must be changed, use the <
↑
> and <
↓
> keys to change the setting from YES to NO. If the desired setting is
visible, press the <#> key to confirm. The display will then change to:
Zone bypass
enabled NO
If you wish to change another setting of this zone, press <#> to continue to the next setting. If this setting
must be changed, use the <
↑
> and <
↓
> keys to change the setting from YES to NO. If the desired setting is
visible, press the <#> key to confirm. The display will then change to:
Entry/Exittime:
030/045 seconds
Now enter the desired entry and exit times. When an entry time of 60 seconds and an exit time of 30 must be
programmed, enter 060030, followed by the <#> key to confirm. The new entry and exit times are now
programmed and the display jumps to the first setting of the next zone.
To leave the zone programming mode, press the <*> key a few times until the keypad has returned to the
idle state.
Attention:
All zone settings can be changed with function 28 except for the zone name programming. The
zone name must be programmed with a laptop and the Winterm software.
F29# Programming the access control system (Proximity Reader)
All characteristics of the AlphaVision NG access control system are programmed with function <29>.
Before the NG Proximity Readers can be programmed, all must be installed and set to the right addresses.
To do this, follow the instructions in chapter “Installing the Proximity Reader”.
Press <?><2><9><#> followed by the installer code. The LCD display will change to:
Enter number of
Prox Reader: .
Now enter the address of the NG Proximity Reader of which you wish to change the programming. When
there is no Proximity Reader with the address you have entered, the text “
Module not present
” will
appear in the display. When you have, for instance, entered address 2, and this Proximity Reader is present,
the following will appear in the display:
AlphaVision NG installation manual Rev. 2.0 27-08-2003 Blz. 85/101
NG Prox Reader 2
