ALGE-Timing TDC8001, Manual

Page: 50 / 112

Manual
TdC 8001
-50-
LED-Brightness Menu 55 Default = 9
When using LED-display boards from ALGE-TIMING you can adjust the brightness of the LED in 10
levels. The value 0 is relatively dark (e.g. when using it at night), the value 9 is the brightest (e.g. when
you have sunshine).
Menu 55: LED-BRIGHTNESS = 9 Input: 0 to 9
Save with: ENTER exit with <ENTER>
Displaytime to next StNo Menu 56 Default = 3 seconds
After the start the bib will stay for the duration of the adjusted time before it changes to the next bib (only
when using Automatic bib counting on UP or DOWN. This is important to avoid in case of double im-
pulses that the next bib start by accident.
Menu 56: DISPLAYTIME TO NEXT STNO = 3 Input 0 to 9 seconds
Save with: ENTER exit with <ENTER>
Add PTO Immediately Menu 57 Default = OFF
The PTO is a penalty time that in show jumping that a competitor can get if the horse refuses to jump a barrier
but the barrier drops. If you ADD PTO IMMEDIATELY, then it adds this penalty time already to the running time.
Latching Blockkeys Menu 58 Default = OFF
Is used for show jumping and agility. When you select LATCHING BLOCKKEYS = ON, than you do not have to block
permanent the block key for start and finish to avoid wrong timing impulses. If you press once on the BLOCK key
you can activate the start or finish. When using the next bib the “Block-Mode” again active.
This menu has also a second selection with PRINT BLOCKTIMES. If you have this on ON it will print and store the
time of day of “blocked” impulses (but the time will not stop).
Menu 58: LATCHING BLOCKKEYS = OFF Input ON or OFF
PRINT BLOCKTIMES = ON
Input ON or OFF
Change: YES/NO Save with: ENTER exit with <ENTER>
Pulse from Radio Menu 59 Default = all OFF
When receiving impulses by radio (e.g. WTN or TED) it is possible to activate by selection <YES> for
the channel that the time delay cause by the radio transmission (0.1 sec.) will be automatically corrected.
Menu 59: Pulse from Radio: Channel 0 = YES< Channel 0 is switched on
Channel 1 = NO Channel 1 is switched off
Channel 2 = NO
Channel 2 is switched off
Save with: ENTER Channel 3 = NO Channel 3 is switched off
Attention: Until version 13.31 this menu was called „Impulse from TED“.
Startnumber-Info RS232 Menu 60 Default = OFF
If this menu is active it will output two information through RS232 and RS485 when you input the bib for the
start. As soon as you start to input a number it will output s0000. When you confirm the new bib with <ENTER>
it will output sXXXX (XXXX = bib). The same happens at the input of a finish bib with n0000 and nXXXX.
When you use a mode that switches the bibs automatically it outputs only nXXXX or sXXXX.
This information about the bib goes also through the RS232 interface on channel 2.