ALGE-Timing TDC8001, Manual

Page: 21 / 112

Manual
TdC 8001
-21-
3.1.2 Turning on and continuation in the same heat
− The activation operation is the same as with the 1. Heat.
−
As the race is continued in the same heat, the memory must not be cleared.
−
Select correct race.
− The info display (7) shows as follows:
Select heat: SAME (1) < F1 The number is for 1. Heat
NEXT (2) F2 The number is for 2. Heat
Continue: ENTER
− Press <F1> and <ENTER> to select and confirm the same heat.
−
Re-synchronize timing device or use internal clock as time of day.
−
The timing device is ready.
3.1.3 Second (next) heat
Up to 256 heats can be carried out. In every heat the total time from the previous heats as well as the
current heat are saved. There are two possibilities to switch to the next heat:
− Turn off TdC 8001 and on again
− Change heat in the main menu (see chapter 0).
−
For every competitor the following times are printed:
0012 SZ 10:07:04.640 Start time (time of day)
ZZ 10:08:35.150
Finish time (time of day)
LZ 1:30.50 Run time
MZ 1:32.38
Memory time
TZ 3:02.88 Total time
In the main menu (menu 8) you can set if the time starts at zero or at the total time of previous heats.
After crossing the finish line display (7) first shows run time, then total time or first total time, then run
time and again total time. Set the display time for the run time and total time in main menu (menu 4/5).
Change heat in main menu
Advantage:
no re-synchronization necessary; all pre-set value are stored.
Disadvantage:
In case of long breaks in between heats the device is always activated. I. e. the longer
the break the more time deviation happens. Without connected mains supply, energy
from the batteries is spent.
−
Press <ALT> and <MENU> at the same time.
−
Select “Change heat” in menu 24 with the cursor.
Menu 24: CHANGE HEAT
Select: YES/NO or Menu number: 24
− Press <YES>
Select heat: SAME (1) <
F1 continue in same heat
NEXT (2) F2 next heat
Continue: ENTER
− Select next heat with <F2> + <ENTER>. The number in parentheses shows the heat number.
Start order: START NUMBER < F1
BIBO WITHOUT GROUPS F2
BIBO WITH GROUPS
F3
Continue: ENTER