ALGE-Timing TDC8001, Manual

Page: 11 / 112

Manual
TdC 8001
-11-
2.2 Printer
The TdC 8001 has an integrated thermal printer. The original
ALGE
paper is best suited for this printer.
You can recognize the paper by the
ALGE
logo on its back. It is available with your
ALGE
agent
The printer is very user friendly. The print head does not move and the roll is integrated in the paper
cover. Replacing the paper is therefore very easy.
The printer works very fast and silent. With external power supply up to 6 lines are printed per second,
with battery operation 4 lines per second. It is automatically activated when turning the TdC 8001 on.
As soon as a program of the TdC 8001 is activated, your can set the following with the key <PRINT>:
Print Mode: All printer data is printed. After turning the TdC8001 on, the print mode is activated
automatically.
Buffer Mode: All printer data is stored but not printed. This mode should be activated during paper
replacement
- Printer in print mode, press <PRINT>
- Printer in buffer mode; <PRINT>
- Printer switches to print mode and prints all stored data
Turn Printer Off: Printer is turned off and sent data is lost.
- Printer in print mode; press <ALT> and <PRINT> at the same time
- Printer is off; press <PRINT> or <ALT> and <PRINT> at the same time
- Printer in print mode
Replace Paper: - Open paper compartment
- Replace empty roll by new one
- Thread through yellow cover at tearing edge
- Close printer cover
- Note: Make sure that the paper protrudes through the edge when placing the
cover on the device.
- A red stripe on the thermal paper indicates a soon end of the paper.
During the print out you must not tear at the paper strip as otherwise the paper will jam. If the paper is
jammed, press black lever forward (direction of the arrow) and at the same time carefully tear the paper
out. Keep the paper dry.