Alcatel Speed Touch 591s, Technical User'S Manual

Page: 70 / 184

6 — Configuring frame relay connections
6-4 Speed Touch 591s Technical Practices
90-8785-01 February 2001
Procedure 6-3 Disconnecting an endpoint
A connection can be disconnected by disconnecting either endpoint.
CONFIG — CONNECT — <endpoint>
↵
— DISCONNECT
where endpoint is in the format <U;S1/Ddlci> or <U;Ddlci>, and dlci is a value from 16 to
1007, or <N;0/vci>, and vci is a VCI number from 32 to 157
6.2 Configuring frame relay traffic parameters
Table 6-1 lists the traffic parameters that can be configured on the ST591s.
Table 6-1 Traffic parameters
Note
(1)
Access rate is the effective maximum bandwidth of a frame relay port.
Procedure 6-4 Configuring the service category
CONFIG — CONNECT — <endpoint>
↵
— TRAFFIC — FROM_1
→
2 — FR_SERV_CAT —
REAL_TIME or LOW_DELAY or COM_THRUPUT or BEST_EFFORT*
where endpoint is in the format <U;S1/Ddlci> or <U;Ddlci>, and dlci is a value from 16 to
1007, or <N;0/vci>, and vci is a VCI number from 32 to 157
For further information on service categories, refer to Alcatel 7350 ASAM Technical
Practices.
Parameter Possible values Default value
FR service category REAL_TIME
LOW_DELAY
COM_THRUPUT
BEST_EFFORT
BEST_EFFORT
Policing Enable, Disable Enable
Rates CIR 0 - AR kb/s
(1)
0 kb/s
Bc 0 - 65535 kb/s 0 kb/s
Be 0 - 65535 kb/s AR kb/s