Alcatel Speed Touch 591s, Technical User'S Manual

Page: 47 / 184

4 — Configuring generic node parameters
Speed Touch 591s Technical Practices 4-3
February 2001 90-8785-01
Configuring the serial port baud rate
The Speed Touch 591s provides a serial port for connection to serial
transmission-based node management terminals. Initially, the baud rate of the node
management terminal must be set to match the Speed Touch 591s default value of
9.6 kb/s to establish communication. After the terminal establishes connection, a new
baud rate can be configured for the serial port.
If the serial port baud rate is changed, the change takes effect when PROCEED is
selected. Change the baud rate of the node management terminal to match the new
baud rate of the serial port.
Procedure 4-1 Configuring the baud rate
HOUSE — SER_PORT_1 — BAUD_RATE — 600 or 1200 or 2400 or 4800 or 9600* or 19200
Configuring the node name
When the node name is configured, it is displayed in the header line. If it is not
configured, the node name is left blank.
Procedure 4-2 Configuring the node name
HOUSE — NODE_NAME — <name>
↵
where name contains a maximum of 12 alphanumeric characters excluding space, tab,
question mark, and percent sign
Configuring the NMTI session timeout
The session timeout for the NMTI on the Speed Touch 591s can be configured or set
to zero (0) to disable it.