Alcatel Speed Touch 591s, Technical User'S Manual

Page: 120 / 184

12 — Configuring T1/E1 CE channel groups
12-2 Speed Touch 591s Technical Practices
90-8785-01 February 2001
12.1 Configuring channel groups
The softkey structure for configuring channel groups on the T1 circuit emulation
version is shown below.
One or more channels of an E1 or T1 CE port in SDT mode can be grouped into a
channel group. The channel group acts as a single super-rate endpoint. The channels
in the group can be contiguous or noncontiguous; however, the channels must
maintain their end-to-end time ordering. Refer to Alcatel 7350 ASAM Technical
Practices for further details.
A channel group consists of 1 to 24 channels for a T1 CE port and 1 to 31 channels
for an E1 CE port. For an E1 CE port in CAS mode, channel 16 is reserved for
signaling and cannot carry data. A channel can belong to only one channel group.
A channel group is identified by the lowest-numbered channel in the group. For
example, if the channel group consists of channels 4, 5, 6, and 7, the channel group
is identified as CG4.
SK002852
NUM_DATA_OCT
CONFIG
OBJECT
CHANNELGROUP <endpoint>
↵
PLAYOUT_BUFF <value>
↵
ADD_CHANNEL <channel>
↵
NAME <name>
↵
DEL_CHANNEL OPTIONS SHOW_GROUPS
ALL <value>
↵
Note — Channel groups can be configured only when the AAL
service is configured to SDT. No channel groups can be configured in
UDT mode.