Configure
Left running head:
Chapter name (automatic)
24
Beta
Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
Step 2:
Configure primary IP address in the
Basic
table.
1.
Enter the IP address and subnet mask for the interface in the
IP Address
and
Mask
field.
2.
Enter description for the interface in the
Description
field.
3.
Associate a VRF to an interface. Select the VRF to be associated from the VRF
list. The selected VRF is displayed in the
VRF Forwarding
field.
Note:
By default, all the interfaces are associated with the Default VRF.
4.
Click
Apply
to add the details, or
Reset
to retain the original details.
5.
Click
Remove
against the respective fields to delete the configured IP address
and the selected VRF.
Step 3:
Configure secondary IP address for the interface in the
Secondary
table.
Click
New Secondary Address
to add a new secondary address to the selected
interface. Fields to enter the IP address is populated.
1.
Enter the secondary IP address and subnet mask for the interface in the
IP
Address
and
Mask
column.
2.
Click
Apply
to add the secondary IP address, or click
Cancel
to cancel adding
secondary IP address.
3.
Click
Delete
icon in the Action column to delete the secondary address.
Step 4:
Configure advanced details in the
Advanced
table. The table displays the
default values. You can retain the same or configure as required.
1.
Select the required Duplex
operation to be configured on the interface from the
Duplex
drop-down list:
Auto/Full/Half.
Full-duplex refers to the ability of a network, to send and receive data at the
same time.
2.
Select the flow control option for the incoming traffic from the
Flow-Control
Received
drop-down list:
On
/
Off
3.
Enter the MTU value (Maximum Transmission Unit) of the interface, i.e., the
maximum packet size that the interface can accept in the
MTU
field (in the range
64 - 1500).
4.
Select the flow control option for the outgoing traffic from the
Flow-Control Send
drop-down list:
On
/
Off
5.
Click
Apply
to add the set values, or click
Reset
to retain the original values.
PPP
O
E E
NCAPSULATION
ON
FE I
NTERFACE
Step 1:
Click
PPPoE Encapsulation
to set PPPoE encapsulation on the interface
and to configure its parameters. The following page is displayed:
