C o m m i ssion ing M anu al
E st ab l i sh i n g B S R - S P R L i n k w i t h Au t o C o n n ect
5.
6.
7.
WipManage request and receives from this correct BSR (
BSR #2
), the following
parameters:
BSR (
BSR #2
) Air MAC address
SPR subnet mask
BSR (
BSR #2
) transmission rate (3 or 4 Mbps)
WipManage sends the configuration parameters to the SPR. These parameters
include:
BSR (
BSR #2
) Air MAC address
SPR Air MAC address
BSR (
BSR #2
) IP address
SPR IP and subnet mask address
SPR transmission rate ((3 or 4 Mbps)
SNMP and TFTP QoS class
The SPR disconnects from the original BSR (
BSR #1
), and then connects to the
appropriate BSR (
BSR #2
) according to the received parameters.
The SPR continuously sends Config Request traps (up to 10) to the management
station until the management station acknowledges these traps. Once the
management station acknowledges these traps, the AutoConnect process ends.
The SPR does not undergo AutoConnect in the future, even if switched off and
then powered on again. From now on, the SPR will always establish a link with
the changed BSR (
BSR #2
).
01040311-07
Airspan Networks Inc.
8-7
