C o m m i ssion ing M anu al
C h an g i n g L i n k f r o m R o u t er t o B r i d g e
5.
a.
Apply factory default settings by performing the following:
On the toolbar, click the
Set Factory Default
button.
A Warning message box appears.
Figure
6-10: Warning message box for setting defaults
b. Click
Yes
to confirm applying factory defaults to the device.
A Warning message box appears, requesting you to confirm device reset.
Figure
6-11: Warning message box for resetting device
c.
6.
Click
Yes
to reset the device with default settings.
From the
Mode
drop-down list, select
Bridge
(i.e. transparent bridging).
Note:
If in the SPR’s ROM, the SPR is defined as an IP router, then the Mode
field displays Router; If the SPR is defined for transparent bridging, then the
Mode field displays
Bridge
.
7.
8.
In the
Eth IP Address
field, enter the SPR’s IP address (e.g.
10.0.0.11
) so that it
is in the same subnet as the BSR.
In the
Eth Subnet Mask
field, enter the SPR’s subnet mask address (e.g.
255.255.255.240
).
01040311-07
Airspan Networks Inc.
6-13
