Page
33
of
84
EXAMPLE:
Three stage rundown with unfasten on the last stage. (Rundown Back-off)
This example shows a typical three stage rundown with a back-off stage at the end of the rundown.
NOTE:
The unfasten stage’s audit parameter is set to false, therefore, the torque and angle reported are
from the fastening portion of the rundown.
EXAMPLE:
Four stage rundown with an unfasten stage in the middle. (Rundown back off Rundown)
NOTE:
The peak torque was reset at the start of the fastening stage. The torque reported was from the
final stage.
