Page
35
of
84
PSet Number
: Choose any current PSet already configured in
controller.
Action:
•
None:
Will stay in current sequence.
•
Next:
will advance to next sequence set up after count is
reached.
Count:
Fastener number required to complete sequence.
Once values are entered press
two times to return to Job screen
4.3.2 Advanced Options
Lock on Reject:
When enabled, this prevents tool from starting a new rundown if the result of the last
rundown was a reject. Tool remains locked until one of the four Unlock Mode conditions above are
satisfied.
Unlock Mode:
•
Reverse:
Running tool in disassembly mode.
•
Reverse and Throttle:
Running tool in disassembly mode.
•
Reverse and Unlock Torque:
Exceeding “Unlock Torque”
while tool is in the disassembly direction (backing off a
rejected fastener).
•
MFB:
Pressing MFB button on tool (regardless of MFB
configuration).
Unlock Torque:
If Unlock Mode is set to “Reverse and Unlock
Torque”, this torque value must be exceeded when the tool is in
the disassembly direction in order to unlock the tool.
Limit Reject Parameters:
Enable/Disable
Maximum Rejects:
Enter # of rejects allowed
Report Missing Fasteners:
Add an option to each JOB that would allow us to report any
missing fasteners. When it is set, the controller will report an NOK
rundown for each fastener that is defined in the JOB but has not
been ran. These NOK results will be reported whenever a new job
is started AND the prior JOB is incomplete.
These generated NOK results are treated like any other fastening.
They are displayed on the run screen, stored in the results and
transmitted on all protocols.
