58
AcraDyne Gen IV iAC Controller Manual
Pulses Ok
Supported Feature
Bus Element
Bit
0-32
Polarity
N.O./N.C.
Mode
Normal, Timed, Flash
Time Width Offset
Input
Bus
Input
Element
Input
Bit
√
√
√
√
√
The “Pulses Ok” output assignment will go active at the completion of a fastening that has an acceptable pulse
count. It will go inactive when the next fastening is started (the torque exceeds the threshold value) or a Job reset.
Pulses NOk
Supported Feature
Bus Element
Bit
0-32
Polarity
N.O./N.C.
Mode
Normal, Timed, Flash
Time Width Offset
Input
Bus
Input
Element
Input
Bit
√
√
√
√
√
The “Pulses NOk” output assignment will go active at the completion of a fastening that has an unacceptable pulse
count. It will go inactive when the next fastening is started (the torque exceeds the threshold value) or a Job reset.
Pulses High
Supported Feature
Bus Element
Bit
0-32
Polarity
N.O./N.C.
Mode
Normal, Timed, Flash
Time Width Offset
Input
Bus
Input
Element
Input
Bit
√
√
√
√
√
The “Pulses High” output assignment will go active at the completion of a fastening that has an pulse count
that exceeds the high limit. It will go inactive when the next fastening is started (the torque exceeds the
threshold value) or a Job reset.
Pulses Low
Supported Feature
Bus Element
Bit
0-32
Polarity
N.O./N.C.
Mode
Normal, Timed, Flash
Time Width Offset
Input
Bus
Input
Element
Input
Bit
√
√
√
√
√
The “Pulses Low” output assignment will go active at the completion of a fastening that has an pulse count that
falls below the low limit. It will go inactive when the next fastening is started (the torque exceeds the threshold
value) or a Job reset.
ON
Supported Feature
Bus Element
Bit
0-32
Polarity
N.O./N.C.
Mode
Normal, Timed, Flash
Time Width Offset
Input
Bus
Input
Element
Input
Bit
√
√
√
√
√
The “ON” output assignment will be active when the controller is powered up and remains active until power down.
Job Aborted
Supported Feature
Bus Element
Bit
0-32
Polarity
N.O./N.C.
Mode
Normal, Timed, Flash
Time Width Offset
Input
Bus
Input
Element
Input
Bit
√
√
√
√
√
The “Job Aborted” output assignment will go active if a Job is aborted. It will go inactive when the job is reset.
Tool In Use
Supported Feature
Bus Element
Bit
0-32
Polarity
N.O./N.C.
Mode
Normal, Timed, Flash
Time Width Offset
Input
Bus
Input
Element
Input
Bit
√
√
√
√
√
The “Tool In Use” output assignment will go active when the trigger is pressed, whereupon a timer will restart. It
will go inactive when the specified time is reached without becoming active in between.
Barcode Scanned
Supported Feature
Bus Element
Bit
0-32
Polarity
N.O./N.C.
Mode
Normal, Timed, Flash
Time Width Offset
Input
Bus
Input
Element
Input
Bit
√
√
√
√
The “Barcode Scanned” output assignment will go active when a barcode is scanned. The ID # (1-4) will
activate the corresponding bit, if it is covered by the number of bits configured. The maximum size is 4 bits. All
bits will go inactive when a tool reaches the InCycle threshold of a rundown or when they are reset.
