Commonly Used Procedures 6
Agilent Nano Indenter G200 User’s Guide
6-26
, the locking pins are installed at right angles to
each other.
Figure 6-37
Insert locking pins at 90 degrees
2
Place two locking pins through the collar (bottom cover) and
indenter shaft by gently inserting them through the collar and shaft
with a twisting motion, using minimal force. If the first locking-pin
hole is difficult to penetrate, try the other hole first.
3
After inserting the locking pins, click
OK
in the Change Indenter Tip
dialog box, shown in
4
Gently dock the
so that
the retaining nut fits between the remover flats, illustrated in
Figure 6-38
Alignment of indenter shaft, tip and retaining nut
