Agilent Technologies GS8210, Programming Manual, Page: 8 / 352

viii N9360A Multi UE Tester GSM Programming Manual
Using the Status Registers 4-16
Why Would You Use the Status Registers? 4-16
Status Register System 4-19
Error Messages 4-23
5 Programming Command Reference 5-1
IEEE Common Commands 5-2
IEEE Common Commands Reference 5-2
Top Menu Commands 5-5
System Commands 5-5
Display Commands 5-6
Application Select Commands 5-8
Initial Softkey Screen Commands 5-9
Configuration Screen Commands 5-9
Command Reference for Configuration: Network Setting Screen 5-12
Command Reference for Firmware Update 5-15
Command Reference for Update Flash 5-21
DISPlay Subsystem 5-23
DISPlay Subsystem Command Reference 5-23
Command Reference for Automatic Test Screens 5-25
Command Reference for Manual Test Screens 5-26
Command Reference for TX Analyzer Screens 5-27
Command Reference for Signal Generator Screen 5-28
Command Reference for Configuration Screens 5-28
INITialsoftkey Subsystem 5-31
CONFigure Subsystem 5-32
CONFigure Subsystem Command Reference 5-32
Command Reference for Configuration: Test Sequence Screen 5-34
Command Reference for Configuration: Test Condition Screen 5-58
Command Reference for Configuration: Test Condition (Loss) Screen 5-78
Command Reference for Configuration: Test Condition (BA) Screen 5-79
Command Reference for File Management Screen 5-81
Command Reference for Network Setting Screen 5-85
TESTs Subsystem for Automatic Test 5-89
Command Reference for Stand-by/Measuring Screens 5-89
Command Reference of Tests Results 5-96
Command Reference for Peak TX Power Measurement Screen 5-99
Command Reference for Burst Timing/Power Ramp Measurement Screen 5-100
Command Reference for Phase/Frequency Error Measurement Screen 5-104
Command Reference for Sensitivity/RX Quality/RX Level Measurement
Screen 5-114