5-146
N9360A Multi UE Tester GSM Programming Manual
5
Programming Command Reference
Command Reference for Peak TX Power/Burst Timing/Power Ramp
Measurement Screen
The TPOWer and TXAMplitude commands are used to set or get
the controls and parameters associated with the Peak TX
Power/Burst Timing/Power Ramp measurements and the
pass/fail tests.
Power Ramp Graph Zoom
TESTs:MANual:RESults:RAMP:ZOOM ON|OFF|1|0
TESTs:MANual:RESults:RAMP:ZOOM?
This command sets whether to activate the zooming function on
the Power Ramp graph screen. Parameter is
ON
(1) or
OFF
(0). If
the parameter is set to
ON
, the rising and trailing edges are
expanded. At preset, this is set to
0
.
The query command returns the selected zooming function on
the Power Ramp graph screen with integer value of
1
or
0
. The
meaning of the return value is same as that of the command
parameter.
Power Ramp Marker Measurement
TESTs:MANual:RESults:RAMP:MARKer?
This query command returns values at marker position on the
Power Ramp graph screen with values,
<int 1>
,
<int 2>
,
<real 3>
, and
<real 4>
. Each value is separated by a comma.
•
<int 1>
(1 digit) is
0
if measurement result is within the
measurement range, or
1
if measurement result is out of
range or the Power Ramp is not measured.
•
<int 2>
(1 digit) is the test result for the
0
(pass) or
1
(fail).
•
<real 3>
(up to 7 letters) shows the different results
responding to the mode and modulation.
GSM/GPRS/EGPRS (MCS1-4):
<real 3>
is the marker position
in bits ranging from
-9.25
to
156.25
when the zoom function is
set to
Off
, or from
-8.00
to
2.00
and
145.00
to
155.00
when the
zoom function is set to
On
.