5-42
N9360A Multi UE Tester GSM Programming Manual
5
Programming Command Reference
Peak TX Power Test
CONFigure:SEQuence:TPOWer:HIGH <int>
CONFigure:SEQuence:TPOWer:HIGH?
CONFigure:SEQuence:TPOWer:MEDium <int>
CONFigure:SEQuence:TPOWer:MEDium?
CONFigure:SEQuence:TPOWer:LOW <int>
CONFigure:SEQuence:TPOWer:LOW?
These three commands set whether to execute the Peak TX
Power test at High, Medium and Low ranges in the test sequence
on the six measurement channels.
<int>
sets whether to
execute this test on each Traffic Channel by the total sum of 6
bits as follows.
bit 0 (1): Testing on the TCH1
bit 1 (2): Testing on the TCH2
bit 2 (4): Testing on the TCH3
bit 3 (8): Testing on the TCH4
bit 4 (16): Testing on the TCH5
bit 5 (32): Testing on the TCH6
The value in the parentheses is decimal value for each bit. Refer
to
Setting and Querying the Registers
The set of each bit is
1
for Run and
0
for — (skip). At preset, this
is set to
63
.
These query commands return the set of the Peak TX Power test
at High, Medium and Low power ranges with integer. The
meaning of the return value is same as the parameter of the
command parameter.