M47 User’s Guide - Page 93
Symptom
Explanation
Action
Cannot print.
Is the READY light
off?
If so, this printer is
offline or in menu
setting mode.
Check the control panel display: “Off-
line” Press <On Line>
Others
Press the Back Arrow button to exit
the menu setting mode.
Is there a message
displayed on the
control panel?
Follow the message to rectify the
problem.
See page 103
When a parallel
cable is used for
connection, are you
using a computer
that supports
bidirectional
communication?
By default, the printer’s bidirectional
communication setting is set
to [Enable]. If the computer is
not responding to bidirectional
communication, printing cannot be
done.
Turn the bidirectional communication
setting to [Disable] on the control
panel and then print again.
The printer has
insufficient memory
to print the job.
If the printer driver is set to [1200dpi]
on the [Graphics] tab, change it to
[600dpi].
Install additional memory (optional) in
the printer.
Reduce the complexity of the print
job.
Print job is
sent, but the
READY light is
not on.
The interface
cable may be
disconnected.
Turn off the power and check the
connection of the interface cable.
Is the interface
configured?
Check the port status of the interface.
The computer
environment is not
correctly set up.
Check the computer environment,
such as the printer driver.
Summary of Contents for M47
