Accu-Turn 1220, Operator'S Manual

Page: 78 / 96

78
ACCU 12
2
0
Installation Instructions
Operator’s Manual
iii-1
iii-2
iii-3
iii Installation procedures.
Wheel balancer:
Refer to the figure in section i to position the wheel
balancer correctly. If the wheel balancer is to be
secured, use concrete lags with a bolt shaft
measuring 8 mm, quality 8.8 or above.
Storage pegs:
•
Unpack the 4 threaded accessory supports and
disks.
•
Refer to Figure iii-1. Mount the 4 threaded supports
and disks.
Stub shaft:
•
Clean the stub shaft and the main shaft.
•
Refer to Figure iii-2. Position the stub shaft on the
main shaft.
•
Use the shaft tightening stud supplied to tighten
completely.
Wheel guard:
•
Refer to Figure iii-3. Bolt the wheel guard assembly
onto the shaft which projects at the back on the right-
hand side.
Cones:
•
Place the cones in the accessory supports.
Clamping devices:
•
Place the clamping devices in the accessory
supports.