Accu-Turn 1220, Operator'S Manual

Page: 66 / 96

66
ACCU 12
2
0
Trouble shooting
Operator’s Manual
7.1.1 E-codes.
When the E-code is displayed, a low beep is generated.
E22
Spinning timeout.
E23
Spinning speed not reached.
E24
Spinning speed too low.
The wheel has failed to be spun up to balancing speed
within the time limit set.
•
Check that the brake pedal or wheel is not blocked
by accident.
•
Check the power supply.
•
Call Technical Service.
E25
Reverse error.
The shaft turned in the wrong direction at a given
speed.
•
Apply the brake.
•
Call Technical Service.
E26
No acceleration.
Shaft acceleration was not detected.
•
Call Technical Service.
E27
Slip detected.
•
The wheel slips on the shaft. Mount wheel properly
insuring that sufficent torque is applied to wing nut.
E28
Speed limit reached.
•
Call Technical Service.
E29
START pushbutton pressed with wheel guard raised.
E50
7.1 System messages.
The wheel balancer can show messages to the
operator. These may be error related (E-codes) or
service related (C-codes). The codes will be described
in the following chapters.
Whenever a code appears:
- write it down
- look up the code in the list. If the code is not
described, call Technical Service.
- perform the steps described.
The format of this chapter is:
Code
Description
•
Step(s) to be performed.
7.1 System messages.
The wheel balancer can show messages to the
operator. These may be error related (E-codes) or
service related (C-codes). The codes will be described
in the following chapters.
Whenever a code appears:
- write it down
- look up the code in the list. If the code is not
described, call ACCU Service.
- perform the steps described.
The format of this chapter is:
Code
Description
•
Step(s) to be performed.
7.1.1 E-codes.
When the E-code is displayed, a low beep is generated.
E22
Spinning timeout.
E23
Spinning speed not reached.
E24
Spinning speed too low.
The wheel has failed to be spun up to balancing speed
within the time limit set.
•
Check that the brake pedal or wheel is not blocked
by accident.
•
Check the power supply.
•
Call Accu Service.
E25
Reverse error.
The shaft turned in the wrong direction at a given
speed.
•
Apply the brake.
•
Call Accu Service.
E26
No acceleration.
Shaft acceleration was not detected.
•
Call Accu Service.
E27
Slip detected.
•
The wheel slips on the shaft. Mount wheel properly
insuring that sufficent torque is applied to wing nut.
E28
Speed limit reached.
•
Call Accu Service.
E29
START pushbutton pressed with wheel guard raised.
E50
Factory calibration not completed.