Accu-Turn 1220, Operator'S Manual

Page: 44 / 96

44
ACCU 12
2
0
Operations
Operator’s Manual
5.3.4-1
5.3.4-2
5.3.4-3
5.3.4-4
5.3.4 Weight application.
The following weight types and application methods
are available:
- clip-on weights.
Always apply by hand.
- stick-on weights.
Depending on the type of wheel, apply by hand or
using the gauge arm.
Note: Weights applied manually must always be
fitted at exactly 90° to the axis (in the 12
o’clock position).
After spinning the wheel (refer to Figure 5.3.4-1):
•
Look at the rotation indicators for the left plane of
the wheel.
If one or more indicators are lit:
•
Turn the wheel until all of the illuminated indicators
are lit (Figure 5.3.4.-2).
•
Press the foot brake to lock the wheel.
The weight to be applied in that plane is shown on the
display.
Attaching a clip-on weight.
Refer to Figure 5.3.4-3.
•
Clip-on weights must always be applied in the 12
o’clock position.
•
The lip should rest on the edge of the rim. Use the
weight pliers to position it.
In STATIC mode only the left hand display is used.
Fitting a stick-on weight.
ALU or STATIC modes only:
Refer to Figure 5.3.4-4.
•
Apply the weight on the rim in the 12 o’clock position
with the correct offset from the “0” point.
Note:
With STATIC wheel types, always apply
the weight at the rim center line. If not
possible, split the weights evenly and
apply on another surface of the rim
(symmetrical to the rim center line).