Accu-Turn 1220, Operator'S Manual, Page: 80 / 96

80
ACCU 12
2
0
Installation Instructions
Operator’s Manual
iii-4
iv Test procedures.
•
Balance a wheel to less than 0.25 oz. (5 grams)
per plane.
•
Perform a User Calibration. See Chapter 6.3.1.
Weight Tray Plane:
•
Rest the weight tray plane on the machine and,
before securing it, pass the keyboard connecting
cables to the outside: the cables are fed in from
the bottom of the Weight Tray Plane and exit
through the top, where the keyboard will be
positioned.
•
Fit the two side screws with metric pitch (1-Fig. iii-
4).
Fit the two black screws on the front (4-Fig. iii-4)
and tighten it normally on the case.
Control panel:
•
Connect the multi-track cable to the connector
behind the panel.
•
Connect the earth cable to the front panel.
•
Apply the Control Panel, angled correctly, carefully
positioned at the centre of its seat on the Weight
Tray Plane.
•
Press on the sides to make the Velcro tape adhere
correctly.
v Instructing the operator.
(Following applies only if a unit is installed by a service
Technician)
•
Show and explain the Safety Booklet.
•
Show the operator how to switch the unit on and
off.
•
Show the operator how to perform an emergency
stop.
•
Show the operator how to select a wheel type, enter
data and apply a weight.