Accom ASWR8150, Technical Manual

Page: 85 / 236

Wipe Generator
A Wipe Generator sub-board is required in the 8150 and is factory
installed at location J6. Two versions are available: Standard and
Advanced. You have the Standard Wipe Generator if some ICs are not
installed on the sub-board; Advanced Wipe Generator boards are fully
populated. In either case, a Wipe Generator sub-board must be installed
for the 8150 to be able to perform transitions other than cuts.
Color Corrector
Either a Color Corrector Bypass sub-board or the Color Corrector
sub-board is required and is factory installed at location J5. The Color
Corrector Bypass sub-board completes M/E and PGM/PST bus row
signal paths and lets the 8150 operate without color correction. This
board is virtually devoid of parts. The Color Corrector sub-board is fully
populated and enables all seven Color Correctors. In either case, a
sub-board must be installed to complete the signal paths for the
Background A, Background B, Program, and Preset buses.
Input Modules
There are five versions of Input modules currently available: Dual Serial
Digital, Dual Parallel Digital, Dual Component Analog, Component
Video + Key, and Composite Video + Key. Each version includes two
inputs per board. The digital Input modules include a color field (matte)
generator for each input, which you can use in place of the connected
input signal. The Dual Component Analog module accommodates RGB
or Y/R-Y/B-Y (at SMPTE/EBU N10, Betacam

, or MII

levels),
monochrome key signals, or composite sync for video sources without
Figure 3-3 I/O Module Options
8150 Technical Guide Option Identification
9100-0212-04 - May 2000
Option Installation
3-5