Repair, Replacement of Spare Parts
Section 7
7-66
Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008
a. J3 at the Y-Sensor Board
b. J8 at the Computer Control Board
5. Then, pull the Interface Cable and its connector from the
front of the unit towards the back of the unit by slipping
between the end of the Top Rail and the right-hand side
panel.
6. Gently lift the cable to pull loose the double-back tape that
fastens it to the drive base, and remove the cable assembly.
NOTE:
Some of the double-back tape may remain stuck
to the drive base. Do not attempt to remove any such
residual tape.
Installation
Reassemble by following the removal procedure in reverse.
CAUTION:
Before sliding the Top Cover back into
position, make sure all wiring, cables and connectors
are replaced snugly, within the unit and not hanging
out where they might be sheared off when replacing
the cover.
NOTE:
Remove the protective backing from the
adhesive on the cable assembly. Align the two (2) white
marks on the cable with the two (2) white marks on the
drive base. With the cable centered between the white
marks on the drive base, press the cable flat against the
drive base.