Section 5
Electrical Test
Abbott VP 2000™ Processor Service Manual
5-47
30-608308/R1—September 2008
31. Verify the Bucket Sensor voltage switching is at:
Check off the following block on the checklist:
SENSOR VOLTAGE
32. Y Motor Torque:
Press the following set of keys:
“ABORT”
“ENTER”
“1”
“ENTER”
33. Next, place an obstruction (cardboard, etc.) on top of the
Rinse Tank/Dryer Cover. Press the down arrow key. The
arm will travel down and hit the obstruction. After
approximately five (5) seconds the fault LED should light
and an audible beep should be heard. Push the “CLEAR”
key and immediately remove the obstruction. The arm
should now continue to move down. Press the up arrow
key.
Check off the following block on the checklist:
ARM FAIL SAFE
34. Place the UUT power switch in the OFF position.
35. Attach the serial printer as shown to the printer/computer
port. Place the UUT power switch in the ON position. Turn
ON the printer and press the following sequence of keys:
“PRINT”
“ENTER”
U13
Pin 6 Front 0 to 3v
.05v
U13
Pin 6 Rear 0 to 3v
.05v