Section 7
Heater Module Control Board
Abbott VP 2000™ Processor Service Manual
7-55
30-608308/R1—September 2008
21. Disconnect all three (3) Heater Basins from the bottom left
connectors on the board using needle-nose pliers to
prevent pulling the wires from the connector.
22. Remove the four (4) 6-32 x 1/4 Phillips-Head screws from
the Control Board mounting panel and remove the
Control Board.
Installation
Reassemble by following the removal procedure in reverse.
CAUTION:
When reinstalling the Heater Box, ensure
the wiring is in the front cavity between the front of
the Heater Box and the front lip of the base. If more
than one (1) Heater Box is removed confirm, that the
Heater Box to Heater Module PC card is correct.
Table 7.1:
Basin Connections
Basin - 1
Color Black
Color Black
PC Board J2 H1
PC Board J2 N
Basin - 2
Color Red
Color Red
PC Board J2 H2
PC Board J2 N
Basin - 3
Color White
Color White
PC Board J2 H3
PC Board J2 N