ABB SCK, System Manual

Page: 95 / 244

42/23-81 EN Rev. 4 System Manual SCK Gas Sampling System 95
Installing the probe retractor
Risk of injury in the area of the gas sampling system due to moving or fall-
ing parts, hot surfaces, anti-freeze, compressed air, lubricating oil
Wear general personal protective equipment:

Closed overalls with long trousers and long sleeves
 Safety shoes
 Safety gloves suitable for mechanical work
 Safety glasses

Protective helmet
 If necessary, additional protective equipment if prescribed by the operator.
Danger of crushing when lifting or lowering the transport unit

Only appropriately trained personnel may transport the transport units and only
with the aid of the recommended transport equipment.

Do not stand under suspended loads.

Follow the transport instructions in these operating instructions carefully.
Risk of burning due to jet flames and hot gases at the uncovered duct open-
ing when the rotary kiln is in operation.
 Preferably install or remove the probe when the rotary kiln is out of operation.

If you install or remove the probe when the rotary kiln is in operation:

Wear a face mask against heat, heat-proof gloves and protective welder's
clothing and respiratory protection against toxic gases.
 Keep the time in which the duct opening is open as short as possible.

6 suspension bolts, diameter 16 mm, material round steel S235JR (St37)
The following requirements must be met in order to install the probe retractor:
 The site conforms to the designated site conditions (criteria see Choosing the
place of installation of the peripheral modules ).
 6 fastening points are present to affix the probe retractor.
 The probe retractor is unpacked.
How to install the probe retractor:
Step Procedure
1
Set up probe retractor at the place of installation.
Mechanical, thermal
and material dangers
Heavy transport units
Hot surfaces, hot
gases, jet flames
Screws required for
assembly
Requirements
Instructions:
Installing the probe
retractor