ABB SCK, System Manual

Page: 106 / 244

106 System Manual SCK Gas Sampling System 42/23-81 EN Rev. 4
Proceed as follows to connect internal electric lines:
Step Procedure
1
On the control cabinet: Turn off the main switch.
2
Install internal lines in accordance with the electrical connection
plan (see appendix). This applies to:
 24 VDC control cabinet-cooling module line
 230/400 VAC cable to cooling-water pump
 230/400 VAC cable to heat exchanger fan motor
 24 VDC cable to probe retractor
 24/26/28/30 VAC cable to probe retractor (option "H")
 230 VAC cable to probe heating (option "60S")
 230 VAC cable to probe retractor

Signal cable to analyzer cabinet
 System bus cable control cabinet - cooling module (see step 3)
 System bus cable probe retractor - cooling module (see step 3)
3
Connecting the system bus cable:
 Install system bus cable from control cabinet to cooling module
terminal box. Connect to the 9-pin D-Sub connector of the CAN
bridge
(1) .

Install system bus cable from the probe retractor terminal box to
the cooling module terminal box. Connect to the 9-pin D-Sub
connector of the CAN bridge
(2) .
4
Connecting the system bus cable to the frequency converter:
 Loosen the short system bus cable with T-piece (2) from its
transport fixing and connect it to the CAN adapter (1) at the fre-
quency converter.
Instructions