ABB SCK, System Manual

Page: 70 / 244

70 System Manual SCK Gas Sampling System 42/23-81 EN Rev. 4
Danger Where / in what situa-
tion does the danger
arise?
Preventive action
Risk of burning due
to hot surfaces, hot
gases, jet flames At the duct opening
when installing the probe
in the rotary kiln
 Preferably install the probe
when the rotary kiln is out
of operation.
If you install the probe when
the rotary kiln is in operation:
 Wear a face mask against
heat, heat-proof gloves and
protective welder's clothing
and respiratory protection
against toxic gases.
 Keep the time in which the
duct opening is open as
short as possible.
Danger due to harm-
ful gases Due to gases escaping
from the duct opening of
the rotary kiln
 Only enter the danger area
around the retractor when
the shutter is closed.
 Lock the shutter before
commencing work.
 Ensure adequate ventila-
tion of the work place.
 If work is unavoidable in the
area of the duct opening,
wear respiratory protection
in addition to the general
protective equipment.
Danger due to harm-
ful anti-freeze In the cooling water of
the cooling system
 Avoid contact with the
cooling water and the anti-
freeze.
 Wash any cooling water or
anti-freeze off the skin im-
mediately with water and
soap.
 If cooling water or anti-
freeze gets in the eyes de-
spite protective glasses,
rinse them thoroughly un-
der running water, holding
the eyelids open.

Observe instructions in the
anti-freeze manufacturer's
safety data sheet.