![background image](http://html.mh-extra.com/html/abb/rdna-01/rdna-01_user-manual_206037.webp)
Drive configuration
37
Note:
The Default values are used when the module is connected
to the drive for the first time. The parameters in the fieldbus group
must be set up for the current application.
01 MODULE TYPE
Shows the connected communication option module type.
02 Module MacID
Selects the MAC ID for the node.
0
…
63
On a DeviceNet network, each node is identified by a unique node
number. This node number is between 0 and 63, and it is called
MAC ID.
Note:
When parameter 04 HW/SW Option is set to 0=HW, this
parameter is read-only and its value is set by DIP switches. See
chapter
Electrical installation
.
03 Module Baud rate
Sets the baud rate for the DeviceNet interface. This is user
selectable, but must be the same on every node on the DeviceNet
network.
0
= 125 kBit/s;
1
= 250 kBit/s;
2
= 500 kBit/s
Note:
When parameter 04 HW/SW Option is set to 0=HW, this
parameter is read-only and its value is set by DIP switches. See
chapter
Electrical installation
.
25
Input I/O Par 9
0 … 32767
0
26
VSA I/O Size
0 … 9
4
Summary of Contents for RDNA-01
