Form No. 3363-440 Rev A
12V Power Plug Adapter Kit
Workman
®
MDE Utility Vehicle
Model No. 07318—Serial No. 310000001 and Up
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
Converter mount
1
Converter
1
Flange bolt (1/4 x 3/4 inch)
4
2
Lock nut (1/4 inch)
4
Assemble the converter.
3
Fuse assembly
1
Install the fuse assembly and electric
mount plate.
4
Power plug assembly
1
Install the power plug assembly.
Bolt (5/16 x 3/4 inch)
2
Lock nut (5/16 inch)
2
Wiring harness
1
5
Wire ties
4
Mount the converter.
1
Preparing the Machine
No Parts Required
Procedure
CAUTION
Batteries can give you a powerful electrical shock.
•
Use tools with plastic handles or wrap the
handles of metal tools with electrical tape.
•
Be careful not to contact both a positive terminal
and a negative terminal at the same time.
1. Position the vehicle on a level surface, engage the
parking brake and rotate the On/Off key to the Off
position.
2. Raise the bed to access the vehicle batteries. Remove
one of the battery cables linking any two batteries
in the bank to remove power from the system
(Figure 1).
Figure 1
1.
Battery link cable
3. Open the front hood to gain access to front end of
the machine.
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
