ABB ACS580-01 drives, Hardware Manual

Page: 90 / 226

90 Electrical installation
Connect the cables
4. Connect the motor cable:
• Ground the shield 360 degrees under the grounding clamps (4a).
• Connect the twisted shield of the cable to the grounding terminal (4b).
• Connect the phase conductors of the cable to the T1/U, T2/V and T3/W
terminals (4c). Tighten the screws to the torque given in table.
5. Connect the input power cable as in step 4 . Ground the shield 360 degrees under
the grounding clamps (5a). Connect the twisted shield to the grounding terminal
(5b) and the phase conductors to the L1, L2 and L3 terminals (5c). Tighten the
screws to the torque given in table.
6. Install the EMC shroud separating the input and output cabling.
7. Reinstall the shroud on the power terminals.
8. Put the unused rubber grommets to the holes in the lead-through plate.
9. Secure the cables outside the unit mechanically.
4a
5b
5c
4b
4c
6
7
L1, L2, L3, T1/U, T2/V, T3/W PE,
N·m lbf·ft N·m lbf·ft
R5 5.6 4.1 2.9 2.1
5a