ABB ACS580-01 drives, Hardware Manual

Page: 41 / 226

Mechanical installation 41
• vertically side by side
Check the installation site according to the requirements below:
• The installation site is sufficiently ventilated or cooled to transfer away the drive
losses. See section Cooling data and noise on page 146 .
• The operation conditions of the drive meet the specifications given in section
Ambient conditions on page 159 .
• The wall is as close to vertical as possible, of non-flammable material and strong
enough to carry the weight of the drive, see section Dimensions, weights and free
space requirements on page 144 .
• The floor/material below the installation is non-flammable.
• There is enough free space above and below the drive to enable cooling air flow,
service and maintenance, See the required free space tables for each of the
different mounting alignments on page
40 (or page 144 ).
Required tools
To install the drive mechanically, you need the following tools:
• drill with suitable bits
• screwdriver and/or wrench with a set of suitable bits (as appropriate for the
installation hardware used)
• tape measure, if you will not be using the provided mounting template.
Frame
size Vertical installation side by side -
Free space
Above (a) Below (b)
1)
Between (c)
mm in mm in mm in
R0 200 7.9 200 7.9 0 0
R1 200 7.9 200 7.9 0 0
R2 200 7.9 200 7.9 0 0
R3 200 7.9 200 7.9 0 0
R4 200 7.9 200 7.9 0 0
R5 200 7.9 200 11.8 0 0
R6 200 7.9 300 11.8 0 0
R7 200 7.9 300 11.8 0 0
R8 200 7.9 300 11.8 0 0
R9 200 7.9 300 11.8 0 0
3AXD00000586715.xls G
1)
Free space below is measured from the frame, not
from the cable box used in frames R5…R9.
a
b
a
b
c = 0