Two-way wireless system ABAX
ACU-100
34
The menu of service functions for the controller interfacing with the INTEGRA control panel:
No autorst.3t.
Tamper
Response period
New device
Active mode
Filter
Configuration
Remove device
Synchronization
Test mode on
Test mode off
Diagnostics of the controller and the wireless devices registered in it is facilitated by using
functions available in the user menu.
Overview of all functions – see Section D
ESCRIPTION OF FUNCTIONS
,
OPTIONS AND COMMANDS
.
11.2 LCD
KEYPAD OF
VERSA
ALARM SYSTEM
In order to select the partition in which tamper alarm will be triggered if the controller is
tampered or disconnected from the bus, and/or to program the response period and name,
you can use the S
ETTINGS
function (S
ERVICE MODE
X
2. H
ARDWARE
X
1. K
PDS
&
EXPS
.
X
2. S
ETTINGS
). After selecting the controller from the list to be displayed, the programming
should be conducted according to the "step by step" method.
The other programming related functions of the ABAX system are available in the ACU-100
submenu (S
ERVICE MODE
X
2. H
ARDWARE
X
1. K
PDS
&
EXPS
.
X
3. ACU-100):
[213#1#]
1. New device
[213#2#]
2. Config. device
[213#3#]
3. Remove device
[213#4#]
4. ACU-100 zones
[213#5#] 5.
Synchronize
[213#6#]
6. Test mode on
[213#7#]
7. Test mode off
For additional information please see the manuals delivered with the VERSA control panel.
11.3
D
LOAD
X
PROGRAM
1. Launch the D
LOAD
X program and establish communication with the control panel (see
P
ROGRAMMING
manual for INTEGRA or VERSA control panel).
2. Click on the
button to open the window showing structure of the security system.
3. Select the "Hardware" tab, and then highlight the wireless system controller in the list of
devices.
4. Program the controller.
5. Having finished entering the new settings, save them in the controller by clicking on the
"Write" button (the
and
buttons in the main menu of D
LOAD
X program are not
intended for reading/writing the settings of the controller and wireless devices supported
by it).
