Two-way wireless system ABAX
ACU-100
16
Consecutive module number
Module address Control input numbers Output numbers
1 0
5–8
9–16
2 1
9–12
17–24
3 2
13–16
25–32
4 3
17–20
33–40
5 4
21–24
41–48
Table 4.
4.5 A
DDING NEW WIRELESS DEVICES
Notes:
•
The procedure of adding wireless devices for the controller interacting with the VERSA
control panel is described in the installer manual of the control panel.
•
If the controller operates with the INTEGRA control panel, firmware version 1.09 or later,
you can select in case of some wireless devices whether it will take one or two positions
(channels) in the list of devices. Depending on the device, if one position is selected:
AMD-102 – only additional inputs will be supported (roller shutter and NC);
ATD-100 – you will only be able to program one temperature threshold;
AVD-100 – only vibration detector will be supported.
4.5.1 D
LOAD
10
and
D
LOAD
X
programs
In order to add a new wireless device to the system, do the following:
1. Press the N
EW DEVICE
button in the program.
2. A window will appear, in which you should enter the 7-digit serial number of the device
being added. The serial number can be found on the electronics board or on the housing.
Each ARF-100 tester has the serial number 0000500.
3. Depending on which device is to be added to the system:
– turn on power supply of the ACX-200 or ACX-201 expander,
– turn on the ARF-100 tester,
– plug the ASW-100 E/ASW-100 F wireless controller into the 230 V socket,
– install the battery in ASD-100 detector,
– violate (open) the tamper contact in case of the other devices.
If an invalid serial number has been entered, you will be informed of it by a suitable
message. Then you should enter the correct serial number and repeat the above
mentioned step.
4. A confirmation message will be displayed that a new device has been added. In case of
the D
LOAD
X program (version 1.09 or later):
– suggested name for the zone/output assigned to the device will appear (the name is
editable);
– you can select for some devices whether it take one or two positions in the list of
devices (INTEGRA firmware version 1.09 or later).
5. Click your mouse on the „OK” button to finish the procedure of new device addition. You
can cancel addition of the new device by pressing the „Abort” button. You can also add a
next wireless device by pressing the „Next” button.
Note:
If the ACU-100 controller is configured for operation as the expander with the CA-64 or
INTEGRA control panels, the procedure of adding new wireless devices to the system
must be followed by the procedure of expander identification in the control panel.
