Page 6 May 2014 – TD 293 OPERATING MANUAL – SmartGuard 5100/5120/5300/5320
Introduction
Purpose and scope
This document is intended to give the reader knowledge of how to operate and maintain the Aanderaa
SmartGuard 5100/5120/5300/5320. All versions are described in a single manual since their basic functions
are the same. They are similar when it comes to configuration of sensor and other device connections, and
communication with the data logger. 5100 is the basic version. 5120 has the same features as 5100 plus
capacity to connect Aanderaa SR-10/VR-22 sensors. 5300 is similar to 5100 but with an expansion module
with extra connectors for analog, digital and serial sensors. 5320 is identical to 5300 plus the capacity to add
Aanderaa SR-10/VR-22 sensors.
Document overview
CHAPTER 1 gives a short description of the AADI SmartGuard
CHAPTER 2 gives a description of the SmartGuard design and basics
CHAPTER 3 describes how to get started with your SmartGuard
CHAPTER 4 describes SmartGuard configuration
CHAPTER 5 describes SmartGuard recording
CHAPTER 6 gives a description of how to add a new sensor to your SmartGuard system
CHAPTER 7 gives a description of the SmartGuard display and its functionality
CHAPTER 8 gives a description of real-time data transfer and local data storage
CHAPTER 9 describes the procedure for upgrading image
Appendix 1 describes the pin configuration of the SmartGuard connectors
Appendix 3 gives an example of a typical Hyd/Met system using SmartGuard
Requirements
AADI Real-Time Collector
Applicable documents
TD 268
Operating manual for AADI Real-Time Collector
TN 313
Technical note for AADI Real-Time Viewer
TD 291
Operating manual for AADI GeoView
TN 362
SmartGuard serial sensor configuration
TN 363
SmartGuard supported protocols
Data sheets for AADI sensors, refer page 8 and 9
