YOKOGAWA AE100D, Инструкция по эксплуатации

Страница: 223 / 464

IM 1F6A0-01E 6-12
6. PARAMETERS
(4) Item D (AUX SETUP)
These items are for Auxiliary setup.
A value in “( )” is the data corresponding to indicator.
[D10:LOW CUT] Low-cut flowrate
Set to noise elimination or zero flow in the low flowrate (or
low frequency) range. The settable range for low cut flowrate
is more than half-minimum flowrate.
NOTE
The low cut can be set after the compensate
items (H25, H30, H40) are set to “NOT ACTIVE”.
It is possible that indication value changes by
the compensated items are set to “ACTIVE”,
however, it does not affect an actual calculation.
[D20:TEMP UNIT] Fluid temperature unit at
operating conditions
Select temperature unit at operating condition from
“degC (0), degF (1)”.
[D21:TEMP f] Fluid temperature at operating
conditions
Set fluid temperature at operating condition.
Range is -200 to 450
°
C
[D25:DENSITY UNIT] Density Unit of Flow
measurement
Select the unit of density from kg/m
3
(0), lb(1), lb/USgal(2),
lb/UKgal(3).
[D26:DENSITY f] Density at normal operation
conditions
Set the density value of the fluid at operating condition for
mass flow unit
[D30:OUT LIMIT] Limit value of output and
indication
Set limit value of output from 100.0% to 110.0%
[D35:BURN OUT] Indication of the output
direction at burn out
This is indication of the output direction at burn out. Refer to
“7.1.6 Burn out” when the output derection can be changed.
[D40:SPECIAL UNIT] Change to special
flowrate unit
Select the availability of changing to special flowrate Unit
from “No(0)” or “Yes(1)”
[D41:BASE UNIT] Indication of the special
flowrate unit
Indication of the basic flowrate unit when item D40 is
“Yes(1)”
[D42:USER'S UNIT] Free unit for users
Set in up to 8 alphanumeric characters when item D40 is
“Yes(1)”
[D43:CONV FACTOR] Convert factor
Set the conversion factor for special units when item D40 is
“Yes(1)”